Xycd60 Manual Guide

Short-press SET to cycle through parameters: UP: Upper limit voltage. dn: Lower limit voltage. OP: Turn-on time (optional delay).

) and opens (cuts off load) when the voltage falls to the lower limit ( 3. Setting Parameters To configure the module, use the following button sequence: Enter Setting Mode: Long press the Switch Parameters: Short press to cycle through parameters: (upper limit), (lower limit), and (time control). Adjust Values: buttons to increase or decrease values. Save and Exit: Long press for 5 seconds to save and return to the main interface. Switch Modes: Long press the button for 5 seconds to toggle between Charging ( ) and Discharging ( 4. Advanced Functions xycd60 manual

This mode is used to protect batteries from deep discharge. The module connects the load when the battery is full and disconnects it once the voltage hits a minimum threshold. Voltage ≥is greater than or equal to UP . Condition to Stop: Voltage ≤is less than or equal to dn . Setting Up the XY-CD60 Entering Setup Short-press SET to cycle through parameters: UP: Upper